lifting an old sbc?

[Vroom_vroom]

ran into an odd question and based on the collective knowledge i thought id ask.

 i have an old sbc im getting ready to yank but it has no accessory holes in the heads. how bad of an idea is it to bolt the chain to a intake bolt? (no intake on it) it has a t10 attached to it as well.

[langss]

Why Not. Probably been done a Million Times before whether under a shade tree or in a comfy garage. 

[SoupMan]

This bracket attaches to the intake manifold and you can lift the engine from that. That's how I did mine.

https://www.amazon.ca/Spectre-Performance-Engine-Lift-Plate/dp/B000BPUU1I/ref=sr_1_1?crid=3VVUTY4MEL9AM&dchild=1&keywords=engine+lift+plate&qid=1620872552&sprefix=engine+lift%2Caps%2C188&sr=8-1

[Vroom_vroom]

i have one i have used before, intake is already off and its not a carb intake anyhow. intake or bell housing/ water pump may be a safer alternative curious to see the clutch that came apart. 

[DeVilliers]

ran into an odd question and based on the collective knowledge i thought id ask.

 i have an old sbc im getting ready to yank but it has no accessory holes in the heads. how bad of an idea is it to bolt the chain to a intake bolt? (no intake on it) it has a t10 attached to it as well.

I took my sbc out and put back in using the bolts on the exhaust headers. I was to scared to use the intake bolt.