« previous next »
Pages: [1]

Author Topic: PTFB spring hanger measurements  (Read 1805 times)

FormTA

  • Oracle Forum Member
  • *
  • Posts: 5703
  • Life is short, have fun, Drive a T/A
PTFB spring hanger measurements
« on: March 29, 2021, 03:27:58 AM »
Does anyone have the measurements of a PTFB rear spring hanger? I nee thw hole to hole measurement of the farthest space ones. I cut mine down planning to only use the lowest setting but my rear is too low now. I will have to make a new set.
Logged
79 Trans am low buck LS swapped
79 Formula 301 (Work in progress)
67 RS Camaro (waiting it's turn)
69 Dodge charger on late model charger chassis
49 Ford F1 on a 2003 Chevy ZR2 Chassis (current project)
Names, Luke. If I hear anyone telling me they're my father....

jonathonar89

  • Oracle Forum Member
  • *
  • Posts: 2510
    • Mark's Cars Inc.
Re: PTFB spring hanger measurements
« Reply #1 on: March 29, 2021, 05:39:58 AM »
Logged
Mark's Cars Inc.

https://markscarsinc.com

FormTA

  • Oracle Forum Member
  • *
  • Posts: 5703
  • Life is short, have fun, Drive a T/A
Re: PTFB spring hanger measurements
« Reply #2 on: March 29, 2021, 10:18:08 AM »
Thanks.... I was hoping someone had a kit they haven't installed yet or one installed they could measure for me.
Logged
79 Trans am low buck LS swapped
79 Formula 301 (Work in progress)
67 RS Camaro (waiting it's turn)
69 Dodge charger on late model charger chassis
49 Ford F1 on a 2003 Chevy ZR2 Chassis (current project)
Names, Luke. If I hear anyone telling me they're my father....

jonathonar89

  • Oracle Forum Member
  • *
  • Posts: 2510
    • Mark's Cars Inc.
Re: PTFB spring hanger measurements
« Reply #3 on: March 29, 2021, 12:11:42 PM »
Quote from: FormTA on March 29, 2021, 10:18:08 AM
Thanks.... I was hoping someone had a kit they haven't installed yet or one installed they could measure for me.

They’re about 1”-1.5” out.  I would not be overly concerned about getting it the same to the .001” measurement.  The main thing is getting your desired stance and make sure whatever distance you create is consistent on each shackle plate you make. Also make sure to check your pinion angle afterwards.
Logged
Mark's Cars Inc.

https://markscarsinc.com

Re: PTFB spring hanger measurements
« Reply #3 on: March 29, 2021, 12:11:42 PM »
You can help support TAC!
Pages: [1]
« previous next »
 

You can help support TAC!