Author Topic: the right way to connect muncie m21 to olds403 on 79trans am  (Read 276 times)

jackoilrain

  • Active Forum Member
  • *
  • Posts: 70
the right way to connect muncie m21 to olds403 on 79trans am
« on: August 25, 2018, 08:57:56 AM »
Hello,

i'm searching right parts to connect muncie m21 trans from a chevy nova, to the olds 403 of my 79trans am.
The second goal is install an idraulic clutch, i've read bad comments about McLeod throwout bearing, i'm not sure wich stuff i must buy...

Advises are welcome,


thanks


SP Steve

  • Active Forum Member
  • *
  • Posts: 258
Re: the right way to connect muncie m21 to olds403 on 79trans am
« Reply #1 on: September 08, 2018, 08:18:25 AM »
You'll need a small block Olds crank drilled for a pilot bushing. Everything else should be bolt in.

Dr87

  • Active Forum Member
  • *
  • Posts: 155
Re: the right way to connect muncie m21 to olds403 on 79trans am
« Reply #2 on: September 08, 2018, 08:20:45 AM »
The 403 crank is drilled and should work fine, I have the same swap in my car minus the hydraulic clutch

Re: the right way to connect muncie m21 to olds403 on 79trans am
« Reply #2 on: September 08, 2018, 08:20:45 AM »
You can help support TAC!