Author Topic: Wanted - EFE vacuum line (steel) 1978 TA GSE 400  (Read 272 times)

Bill Linthicum

  • Forum Member
  • *
  • Posts: 4
Wanted - EFE vacuum line (steel) 1978 TA GSE 400
« on: March 14, 2018, 08:24:21 AM »
I can make one but would prefer to find an original one.  It is the vacuum line (steel) that goes from the EFE flipper located at the base of the driver's side exhaust manifold, up the back of the engine, to the passenger side valve cover.  I then goes to rubber to the vacuum switch next to the thermostat housing.

I tossed mine 30 years ago as a dumb kid.  Any help with helping me locate one would  be greatly appreciated.

Many thanks.

1979 Black and Tan

  • Active Forum Member
  • *
  • Posts: 351
  • '79 in Sunny San Diego
Re: Wanted - EFE vacuum line (steel) 1978 TA GSE 400
« Reply #1 on: March 14, 2018, 11:10:00 AM »
have you tried INLINE TUBE .com?

https://www.inlinetube.com/

they make and sell all kinds of brake and vacuum lines and fuel lines
1979 Trans Am
100% California Car, originally Atlantis Blue/ Black...All Original Unmolested 403, TH350, 2.41
63,300 orig. miles
1971 Chevy K20 4x4

Bill Linthicum

  • Forum Member
  • *
  • Posts: 4
Re: Wanted - EFE vacuum line (steel) 1978 TA GSE 400
« Reply #2 on: March 15, 2018, 05:01:41 AM »
I did after your post but no luck. But thanks for letting me know about the site.  There's definitely lots to look at.



1979 Black and Tan

  • Active Forum Member
  • *
  • Posts: 351
  • '79 in Sunny San Diego
Re: Wanted - EFE vacuum line (steel) 1978 TA GSE 400
« Reply #3 on: March 15, 2018, 04:55:26 PM »
page 108 of their Pontiac Catalog has 403 Olds part...on the left side of the page is the part you are looking for
1979 Trans Am
100% California Car, originally Atlantis Blue/ Black...All Original Unmolested 403, TH350, 2.41
63,300 orig. miles
1971 Chevy K20 4x4

Aus78Formula

  • Oracle Forum Member
  • *
  • Posts: 8562
Re: Wanted - EFE vacuum line (steel) 1978 TA GSE 400
« Reply #4 on: March 15, 2018, 05:53:52 PM »
I'm not sure what part you are referring to in the Olds section, even if it was similar to the 400 part.

Re: Wanted - EFE vacuum line (steel) 1978 TA GSE 400
« Reply #4 on: March 15, 2018, 05:53:52 PM »