Hey guys,
I'm closing in on finishing up the restoration of my car, and have hit a bit of a snag.
I disassembled the steering column, cleaned everything up, and have been re-assembling it. I've gotten to the point where I need to attach the ring that contains the shifter arm to the column.
I took pictures, but not enough, as I don't have a reference for how far down the shaft the ring goes. The below pic is about as good a shot of it as I have:
Below, I've highlighted the area of which I'm talking with a red circle. The arrow is pointing to the outer shaft that the shifter ring attaches to. I'm trying to figure out how much of that outer shaft should protrude from the shifter ring.
I hope my question makes sense. I haven't been able to find any information on this from Google or any of my manuals in the garage. I'm at a loss. Any suggestions?
Thanks!
